Spyderco's Manix 2 Debuts CPM MagnaMax, Larrin Thomas' Follow-Up to MagnaCut

The first production knife in CPM MagnaMax runs a 3.37-inch leaf-shaped blade, a Ball Bearing Lock, and a $180 street price against a $240 list.

2 min read
Published:2026-11-10Folding Knives49 ViewsShare:

Larrin Thomas formulated MagnaCut and reset expectations for folding knife steels, and CPM MagnaMax is his attempt to push further up the wear scale while keeping corrosion resistance in stainless territory. Spyderco picked the Manix 2 as the first production knife to carry it, a pairing the company frames as steel matched to tool rather than a showcase put on hold.

Spyderco Manix 2 with CPM MagnaMax blade etched on the ricasso

The host knife is Eric Glesser's hard-use folder, built in Golden, Colorado, with a Ball Bearing Lock that works from both sides of the handle. Nothing about the design changed for the steel debut. The blade, lock, and ergonomics are the ones Manix 2 owners already know.

The steel, itemized

  • More carbon, niobium, and vanadium than MagnaCut, pushing wear resistance toward high-wear PM tool steels.

  • In Thomas's published cutting tests, MagnaMax cut roughly 40 percent longer than MagnaCut before dulling.

  • Corrosion resistance stays in stainless range, per Spyderco's stated goal of toughness and edge retention rivaling the best high-wear-resistance steels.

The knife around it

  • 3.37-inch leaf-shaped blade, 2.88-inch cutting edge, 0.125-inch stock, full-flat grind.

  • Closed 4.66 inches, open 8.03 inches, 4.9 ounces, with a 14 mm round hole and a textured index-finger choil.

  • Peel-ply G-10 over full steel liners, Ball Bearing Lock, reversible pocket clip for tip-up carry on either side.

The tradeoffs

  • A steel built to shrug off abrasive wear also resists stones. Touch-ups run slow on water stones and routine on diamond or ceramic abrasives.

  • The edge-retention advantage only shows on abrasive work such as cardboard, rope, and strapping. Opening mail never gives the steel a chance to demonstrate anything.

Pricing softens the risk. KnifeCenter lists the Manix 2 MagnaMax at $180 against a $240 list, working-knife money for a debut steel. The question worth answering honestly before buying: does your week cut enough abrasive material to pay the sharpening toll, or would MagnaCut in the same handle still be the smarter daily steel?

—/ 5.0
(No ratings yet)