Four inches of M390 on a 0.19-inch blade slab, 5.4 ounces of aluminum, and a lock bar that refuses to settle in the same place twice. That is the picture from KnifeInformer's new review of the Microtech Socom Elite, published November 12, and it captures a knife that reviewers keep describing in two halves: the build is a tank, the quality control is a coin flip.
The Socom Elite is one of Microtech's longest-running designs, and the review puts the company context up front. The Marfione family started making knives in a garage 26 years ago; the company now runs roughly 100 employees. The knife under review is the manual version, sold around $300 with a 4-inch blade, 9-inch overall length, aluminum handle, liner lock and dual thumb studs. Blade options split along two axes: drop point or tanto, plain or serrated, in satin, apocalyptic or coated finishes. The tested unit wore the apocalyptic finish, a darker stonewash that the reviewer called the best-looking of the three.

Where the knife earns its reputation is strength. The review describes a grind that stays thin behind the edge on the drop point while keeping full stock thickness, a combination that cuts far better than a slab this thick should. On the tanto variant, the spine runs at full thickness from the handle, tapers with a swedge, then thickens again into a reinforced tip. The reviewer's stress scenario, stabbing into lumber and prying laterally, is not a use case for most folders, but the point of the Socom Elite is that it does not care. Next to a Hinderer XM-18 it sits in the same thickness class; next to a Spyderco Delica it belongs to a different sport.
Deployment is the other high note. A crisp detent and heavy blade make the manual open with what the reviewer compares to racking the slide on a 12-gauge pump shotgun. The thumb studs double as blade stops and sit out of the cutting path, and a slanted milled ramp near the stud gives the thumb a consistent launch point. An automatic version exists, though the reviewer prefers manuals for the lighter close.

The lock is where the review turns. Across multiple examples the reviewer has owned, two locked up rock solid, while the current sample's lock bar picks a new position on every cycle, sometimes 15 percent engagement, sometimes the standard 30, sometimes 60 to 70. It sticks, and it shows up-and-down blade play wherever it lands. The reviewer flags this as a known issue on forums, not just one lemon, and calls variable lockup a real problem on a knife this expensive. Everyday slicing takes a back seat too; thick stock behind the edge turns box duty into a chore, though the drop point fares better than the tanto there.
The manual Socom Elite lists around $300 from Microtech dealers in drop point and tanto configurations.