Magnacut is like a more stainless CPM Cruwear. A good balance of toughness & edge retention. It's also not difficult to sharpen; maxamet is super hard and the edge will last a much longer time.
Published
2025-09-25 17:01:08
Share
ARTICLE EVALUATION
What is your rating for this article?
Rated: 4.7 / 5.0More in Knowledge Base
More Articles In This Category
Knowledge Base2026-06-09 14:33:57
What is 8Cr13MoV steel equivalent to?
8Cr13MoV is equivalent to Japanese AUS-8 steel. They share nearly identical chemical compositions and performance characteristics. Both are highly popular budge...
Knowledge Base2026-06-09 14:32:47
Is 7Cr17MoV high carbon stainless steel good?
7Cr17MoV is a decent budget stainless steel , but calling it "high carbon" is mostly a marketing tactic. While it does contain enough carbon to be hardened, it ...
Knowledge Base2026-06-09 14:14:49
Is 8Cr13MoV stainless steel good or bad?
8Cr13MoV is a good budget-grade stainless steel, but it is considered low-end or "bad" if compared to premium, high-cost super steels . It is a Chinese-manufact...
Knowledge Base2026-06-03 07:50:52
H2 steel VS LC200N steel Which is Batter
LC200N steel remains the overall better choice for most users , just as it was against H1 . H2 steel is Spyderco 's modern replacement for H1. While H2 features...